P27D0
Pressure Control Solenoid R Control Circuit High
P27D0 is the high-side counterpart of P27CF for solenoid R: the control line reads too high, most often because it touches battery voltage or another output. GM applies the same driver diagnostics to synchronizer actuation valve 4 of the Corvette dual-clutch box as to the other valves (23OBDG07, 24OBDG07): a sense voltage stuck above 0.7-1.1 V while switched on, a large gap between target and estimated current, or a cross-short to a neighbouring line found during the switch-off routine and reported on the next start, each Type A. Ford's TR9070 overview lists shorted load of SPV4 under this code. A coil with too few ohms can also cause it, so measure resistance before replacing the harness.
Possible causes
- Control line touching battery voltage high
- Cross-short to a neighbouring solenoid line medium
- Solenoid R coil resistance too low medium
- Defective TCM driver low
Symptoms
- MIL on, sometimes only after restart
- Gears on rods 3/4 not available
- Limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27D0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.