P27CD
Pressure Control Solenoid R Control Circuit/Open
P27CD is set when the control circuit of solenoid R appears open, so the module cannot energize the valve. On GM's Corvette with dual-clutch transmission (23OBDG07, again in 24OBDG07) the part is synchronizer actuation valve 4. The test runs with the output switched off: without a coil in the circuit, nothing pulls the sense voltage up to battery level, and it remains between roughly 1.7 and 3.0 V; held for 150 ms, this stores the code as Type A. Ford's TR9070 overview uses P27CD for open load of SPV4. Since valve 4 moves rods 3 and 4 in the B-to-A direction, those shifts become impossible. Causes are mainly a pushed-out terminal, a cut lead or a burnt winding.
Possible causes
- Terminal pushed out of the connector housing high
- Burnt-out winding of solenoid R medium
- Cut or broken control lead medium
Symptoms
- MIL on
- Shifts on rods 3 and 4 in B-to-A direction not possible
- Limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27CD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.