P27C9
Pressure Control Solenoid R Performance/Stuck Off
Solenoid R is the fourth synchronizer pressure valve on the dual-clutch units that use it, and P27C9 says it failed to move anything. GM's 2023 and 2024 Corvette tables (23OBDG07/24OBDG07) call it shift solenoid 4; it acts on the same two rods as valve 3 but drives them back from B towards A. The integrity check commands that motion for each selector position and expects more than 100 µm of rod travel; anything less marks valve 4 hydraulically stuck off, Type A. Ford's TR9070 table lists P27C9 for SPV4. As the opposite direction is affected, the gearbox may be unable to move those rods back, so certain gears can be neither selected nor released.
Possible causes
- Spool of solenoid R stuck closed high
- Supply passage or screen to valve R clogged by debris medium
- Leaking actuator seal on the B-to-A side of rods 3/4 medium
Symptoms
- MIL on with transmission message
- Gear stays engaged or cannot be selected
- Reduced gear range
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P27C9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.