P27C8
Pressure Control Solenoid P Control Circuit High
P27C8 signals too high a level in the control circuit of solenoid P. GM's Corvette DCT tables 23OBDG07 and 24OBDG07 store it for synchronizer actuation valve 3 in three situations, all Type A. First, with the low-side switch on, the sense voltage stays above a supply-dependent limit of 0.7, 0.9 or 1.1 V (below 11.5 V, 12-15 V, above 15.5 V battery). Second, the current estimated from duty cycle and supply deviates from its target by more than 70 % (60 ms) or by more than 400 mA (300 ms). Third, a shutdown routine switches each output separately, detects valve 3 shorted to a neighbour and sets the code at the next start. Ford calls it shorted load on SPV3 of the TR9070.
Possible causes
- Control line shorted to battery voltage high
- Control line shorted to a neighbouring solenoid output medium
- Solenoid P coil with too low resistance (shorted turns) medium
- TCM driver stage fault low
Symptoms
- MIL on, possibly at the start after a previous drive
- Gears of rods 3/4 unavailable
- Limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27C8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.