OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27C7

Pressure Control Solenoid P Control Circuit Low

P27C7 points to a control circuit of solenoid P that is too low, effectively a short to ground on the switched side. GM's 23OBDG07 Corvette dual-clutch table checks synchronizer actuation valve 3 with its low-side switch on and expects the sense resistor voltage to be pulled down only so far; a reading under about 1.7 V (±0.5 V) for 150 ms is reported by the driver chip as a ground short, Type A, provided the engine is not cranking and battery voltage lies between 8.75 and 18 V. With that line grounded, valve 3 may stay energized regardless of command. Ford lists the same failure as a shorted switch on SPV3 of the TR9070. Inspect harness routing near the case and the connector for moisture.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / C7

Possible causes

  • Control wire shorted to ground against the case high
  • Moisture or oil bridging pins in the connector medium
  • Solenoid winding shorted to its housing low

Symptoms

  • MIL on
  • Unwanted application of rods 3/4, gears blocked
  • Limp mode

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P27C7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication