P27C5
Pressure Control Solenoid P Control Circuit/Open
P27C5 reports an open control circuit on solenoid P. GM's Corvette dual-clutch table 23OBDG07 tests synchronizer actuation valve 3 for this while its low-side driver (a TLE8242 chip) is off: an intact coil pulls the sense pin up towards battery voltage, whereas without a load the driver manages to hold it in a window of about 1.7 to 3.0 V. If that persists for 150 ms after the output has been off for over 5 ms, the code sets as Type A, with battery voltage 8.75-18 V and no P0882/P0883 present; 24OBDG07 retains it. Ford's 2024 table lists open load of SPV3 on the TR9070 as P27C5. Look for a broken wire, an unplugged connector or an open coil.
Possible causes
- Open winding in solenoid P high
- Connector not latched or pin pushed back medium
- Broken control wire between TCM and solenoid medium
Symptoms
- MIL on immediately
- Shifts on rods 3 and 4 in A-to-B direction not possible
- Limp mode with restricted gears
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27C5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.