P27C4
Pressure Control Solenoid P Intermittent
P27C4 indicates that solenoid P works most of the time but its circuit or response briefly drops out. No manufacturer documents the code publicly; GM's Corvette DCT table 23OBDG07 and Ford's TR9070 list, which both use this solenoid as synchronizer valve 3, only publish hard faults such as P27C5, P27C7, P27C8 and the hydraulic codes P27C1/P27C2. CARB 13 CCR 1968.2 counts transmission solenoids among monitored outputs. Intermittent dropouts usually come from fretting corrosion at terminals, a conductor broken inside its insulation, or a solenoid whose winding opens when it reaches operating temperature. Logging data while flexing the harness and warming the unit helps catch it.
Possible causes
- Fretting corrosion on connector terminals high
- Wire strand broken inside intact-looking insulation medium
- Solenoid winding that opens at operating temperature low
Symptoms
- MIL that comes and goes
- Occasional harsh or missed shift
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27C4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.