P27C3
Pressure Control Solenoid P Electrical
P27C3 is the general electrical fault code for pressure control solenoid P. No manufacturer documents it publicly. Where solenoid P is known to exist, on GM's Corvette dual-clutch box (23OBDG07, shift solenoid 3) and Ford's TR9070 (SPV3), electrical faults are reported in finer detail: P27C5 for an open load, P27C7 for a shorted switch and P27C8 for a shorted load or excessive current error. A controller with simpler output diagnostics might summarize any of these as P27C3. CARB 13 CCR 1968.2 requires monitoring of transmission output circuits. Measure coil resistance at the transmission connector, then check terminals and the lead to the control unit.
Possible causes
- Solenoid P winding open or shorted high
- Damaged or corroded pin in the transmission connector medium
- Chafed or broken lead between solenoid and TCM medium
- Faulty output stage in the TCM low
Symptoms
- MIL on
- Gears on the affected shift rods unavailable
- Transmission in emergency mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27C3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.