P27C2
Pressure Control Solenoid P Stuck On
P27C2 means solenoid P keeps pressurizing after it should have vented. GM's dual-clutch Corvette table 23OBDG07 (and 24OBDG07) detects this on shift solenoid 3 by watching what happens just after the selector valve switches: if one of rods 3 and 4 travels 1,000 µm or more within 200 ms without a command while the other one drops back by at least 125 µm, valve 3 is judged hydraulically stuck on, Type A. Which rod moves and which relaxes depends on the selector position. Ford's 2024 overview gives P27C2 to SPV3 on the TR9070. Unwanted rod motion can drag a gear in, so the controller usually blocks the affected gears; clunks or a sudden neutral are possible.
Possible causes
- Spool of solenoid P jammed in the open (pressure-applying) position high
- Wear particles in the fluid keeping the valve from closing medium
- Worn valve bore letting pressure bypass to the actuator low
Symptoms
- MIL on and gears blocked by the controller
- Clunk or grinding during gear changes
- Unexpected loss of drive (neutral)
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P27C2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.