P27C0
Pressure Control Solenoid N Control Circuit High
P27C0 reports too high a voltage on the control line of solenoid N, usually a short to battery or to a neighbouring output. On the Corvette with GM's dual-clutch gearbox (table 23OBDG07, 2023), synchronizer actuation valve 2 is flagged when the sense voltage stays above roughly 0.7 to 1.1 V, depending on supply voltage, while the low-side switch is on, or when actual current misses the target by over 70 % for 60 ms or by over 400 mA for 300 ms. A separate test at shutdown energizes the outputs one by one to find two lines shorted together, stores the result and sets P27C0 at the next start. All are Type A; 24OBDG07 keeps the code. Ford's TR9070 list names it shorted load on SPV2.
Possible causes
- Control wire shorted to a supply voltage high
- Two solenoid lines shorted together in the harness or connector medium
- Partially shorted solenoid coil drawing wrong current medium
- Damaged output stage in the TCM low
Symptoms
- MIL on
- Shift rod cannot be actuated; gears missing
- Code returns at every start after a shutdown test
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27C0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.