P27BF
Pressure Control Solenoid N Control Circuit Low
P27BF indicates the control line of solenoid N is pulled too low, in practice a short to ground. GM's 23OBDG07 table for the Corvette dual-clutch gearbox checks synchronizer actuation valve 2 while its low-side switch is on: should the sense-pin voltage fall below about 1.7 V (tolerance 0.5 V), the driver chip reports a ground short; 150 ms confirmation, battery between 8.75 and 18 V, engine not cranking, Type A. With the line grounded the solenoid can be energized permanently and the controller loses control of it. Ford's TR9070 table calls the same event shorted switch on SPV2. A pinched harness against the case or water in a connector are frequent reasons.
Possible causes
- Control wire chafed through to ground high
- Moisture or corrosion bridging the connector medium
- Solenoid winding shorted to its housing low
Symptoms
- MIL on immediately
- Unintended gear actuation or locked-out gears
- Limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27BF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.