P27BE
Pressure Control Solenoid N Control Circuit Range/Performance
P27BE means the control circuit of solenoid N is electrically intact but behaves implausibly, for example a measured current that does not follow the command. No manufacturer documents P27BE publicly. GM's Corvette dual-clutch table 23OBDG07 does monitor exactly this for synchronizer valve 2, comparing target current with the current estimated from duty cycle and battery voltage, but files a deviation above 70 % for 60 ms or above 400 mA for 300 ms under P27C0 rather than here. Ford's TR9070 list also has no entry for it. CARB 13 CCR 1968.2 asks for a functional check of automatic transmission solenoids and, where none is feasible, at least circuit fault detection. Likely causes are a coil with drifting resistance, high connection resistance or a weak driver stage.
Possible causes
- Solenoid N coil resistance out of specification high
- High resistance at connector or crimp medium
- Unstable supply voltage to the TCM low
Symptoms
- MIL on
- Slow or incomplete gear engagement on one shift rod
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27BE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.