P27BD
Pressure Control Solenoid N Control Circuit/Open
P27BD stands for an open control circuit of solenoid N. GM's 2023 Corvette dual-clutch table 23OBDG07 names the part synchronizer actuation valve 2 and tests it while its low-side output is switched off: the driver chip tries to hold the pin at a small voltage with a tiny current, which only works without a load connected. A pin voltage between about 1.7 and 3.0 V after more than 5 ms off, confirmed for 150 ms, sets the code as Type A; the check runs continuously with battery voltage between 8.75 and 18 V and is suspended by supply voltage codes P0882/P0883. Ford's 2024 list uses P27BD for open load of SPV2 on the TR9070. Broken wiring, a loose connector or an open coil are typical.
Possible causes
- Open solenoid N coil high
- Connector unplugged or pushed-out terminal medium
- Broken control wire between TCM and solenoid medium
Symptoms
- MIL on in the same trip
- Gears on the affected shift rod blocked
- Transmission substitute mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27BD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.