P27BC
Pressure Control Solenoid N Intermittent
P27BC reports that the signal or response of pressure control solenoid N drops out now and then rather than failing permanently. No manufacturer documents this code publicly; the GM and Ford dual-clutch documents that use solenoid N for the second synchronizer valve (23OBDG07, Ford TR9070 list) only publish its permanent electrical and hydraulic faults. CARB 13 CCR 1968.2 counts automatic transmission solenoids among the outputs whose circuits must be watched for faults. Loose terminals, a chafed wire that touches only under vibration or heat, or a coil that opens when hot are the usual suspects. Because the fault comes and goes, freeze-frame data and a wiggle test with the harness moved are more useful than a single static measurement.
Possible causes
- Loose or spread terminal at solenoid N or TCM high
- Chafed wire shorting under vibration medium
- Coil opening intermittently when hot low
Symptoms
- MIL that comes and goes
- Occasional missed or delayed shifts
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27BC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.