P27BA
Pressure Control Solenoid N Stuck On
P27BA is the opposite fault to P27B9: solenoid N keeps applying pressure when it should be released. GM's dual-clutch table 23OBDG07 (Corvette) describes the effect of a synchronizer valve 2 stuck on as a constant push on one shift rod. Because the selector routes that pressure differently once the selector moves to another position, one rod relaxes or another moves although no movement was commanded; the TCM watches the rod position sensors for this, Type A, and 24OBDG07 keeps the check. Ford's TR9070 list pairs the same code with SPV2 hydraulically stuck on. Possible consequences are a gear dragging in, gear clash or a forced protective mode, because two gears on one shaft must never engage together.
Possible causes
- Valve spool stuck open by contamination high
- Worn solenoid armature not returning to rest medium
- Fluid contaminated with clutch or synchronizer wear particles medium
Symptoms
- MIL and transmission warning
- Gear clash or grinding on shifts
- Limp mode with restricted gears
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P27BA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.