P27B9
Pressure Control Solenoid N Performance/Stuck Off
P27B9 says pressure control solenoid N does not build hydraulic force when commanded. On dual-clutch gearboxes this letter belongs to the second synchronizer pressure valve: Ford's 2024 summary lists it for SPV2 of the TR9070, and GM's 2023 Corvette table 23OBDG07 calls it shift solenoid 2 hydraulically stuck off. GM runs a synchronizer integrity routine after a shift-related fault or when the gear remembered at shutdown disagrees with the sensors at start-up; small test movements of the shift rods that stay at or below 100 micrometres with valve 2 actuated set the code, Type A, and 24OBDG07 keeps it. The driver may find gears on that rod unavailable.
Possible causes
- Valve spool sticking closed from debris or varnish high
- Low or contaminated transmission fluid reducing supply pressure medium
- Leak in the synchronizer actuator circuit medium
- Mechanically binding shift rod or fork low
Symptoms
- MIL on
- Certain gears cannot be selected; gear skipping
- Substitute mode with reduced gear set
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P27B9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.