OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27B5

Internal Control Module Transmission Gear Ratio Control Performance

P27B5 sets when the supervision software doubts the ratio the transmission is running. Ford describes two triggers in its 2024 summary for the eight- and ten-speed automatics: protection against overspeeding a driveline element (UDS P0701_B1) and a plausibility test of the shaft speed ratio (P0701_64), both non-MIL; the 2020–2023 edition likewise keeps it without MIL on electronically shifted models. Detection takes less than a second. Ford TSB 20-2336 covers 2020 Super Duty trucks with the 6.7 L diesel built up to 19 August 2020, where P27B5 could come with a MIL, other codes and a forced idle; PCM reprogramming was the remedy. Genuine clutch slip or a speed sensor fault can create the same mismatch, so incorrect-ratio codes such as P0730 and sensor codes need checking too.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / B5

Possible causes

  • PCM/TCM software strategy (Ford TSB 20-2336) high
  • Implausible input, intermediate or output shaft speed signal medium
  • Real slip of a clutch producing an unexpected ratio low

Symptoms

  • Warning lamp or wrench light
  • Forced idle or torque reduction
  • Transmission held in a fixed gear

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P27B5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication