P27AF
Pressure Control Solenoid J Data Incompatible
No manufacturer documents P27AF publicly. By its wording it would mean that the TCM considers the stored calibration of a ninth pressure control solenoid, letter J, invalid. GM's published characterization monitor (P27A7 to P27AE, Type A, run at TCM start-up) stops at H, and Ford reports faulty solenoid data on its 10R and 8F transmissions with its own codes P163E and P163F instead of this series. CARB 13 CCR 1968.2 requires transmission output components to be monitored, so a maker with more valves could use J. If it appears, the logic of the GM siblings applies: data missing after a module or valve body change, wrong data set, or a damaged block. A drivable car with MIL and rough shifts is the likely result.
Possible causes
- Solenoid data not loaded after TCM or valve body replacement high
- Data set for another valve body variant medium
- Corrupted calibration block in TCM memory low
Symptoms
- MIL illuminated
- Rough or inconsistent shifts involving the element behind valve J
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P27AF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.