OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27AC

Pressure Control Solenoid F Data Incompatible

P27AC reports invalid calibration data for pressure control solenoid F. On GM's 2016 eight-speed this is the line pressure solenoid, and the TCM logs the fault in one trip once the data are found unprogrammed. Later GM tables assign F to the nine-speed's C4 clutch, the ten-speed's C6 clutch and the CVT's binary pump; the 2025 table 25OBDG03A still carries the check, with the same start-up test and Type A rating. Because line pressure or pump control rides on this valve in some layouts, a bad record can affect every gear, not just one shift. Typical triggers are a replacement controller or valve body installed without the data download; a faulty solenoid coil sets circuit codes instead.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / AC

Possible causes

  • TCM swapped and solenoid F data never loaded high
  • Remanufactured valve body with a new ID not entered into the TCM medium
  • Data block damaged by a voltage drop during programming low

Symptoms

  • MIL on
  • Firm or soft shifts throughout when line pressure depends on valve F
  • Possible fixed-gear substitute mode

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P27AC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication