P27AA
Pressure Control Solenoid D Data Incompatible
P27AA is set when the TCM finds the calibration block for pressure control solenoid D unusable. Which hardware that is depends on the gearbox: GM's 2016 eight-speed assigns D to clutch 4 (C23468), while the 2017-2020 tables put the nine-speed's C2 clutch (CB29), the ten-speed's C5 clutch and the CVT's C1 clutch behind the same letter, so the D used by stuck-off code P2714 is not always the same part. GM checks it once at start-up, Type A. Ford handles the same task differently: its 10R60/10R80 summary reports a bad or empty TRID block holding solenoid data under its own codes P163E and P163F. Reprogramming the data that belong to the fitted valve body clears the fault.
Possible causes
- Solenoid data not loaded after a transmission or TCM repair high
- Used TCM from another vehicle still carrying its old valve body data medium
- Wrong valve body part number used for the download medium
Symptoms
- MIL and stored DTC at key-on
- Rough shifts into gears using the clutch behind valve D
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P27AA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.