P27A9
Pressure Control Solenoid C Data Incompatible
P27A9 concerns solenoid C. GM's controller compares the calibration it holds for this valve with the valve body actually fitted; if the block for C is absent, of the wrong device class, damaged or non-monotonic, the fault is stored at power-up and lights the MIL in that same trip (Type A in 20OBDG04 and in the 2025 table 25OBDG03A). Valve C feeds clutch C1 (CB123456) in the nine-speed, clutch C3 in the ten-speed and line pressure in the CVT; on the 2016 eight-speed it is clutch 3 (C13567). Without valid data the module cannot turn a pressure request into the right current, so clutch fill and shift timing for that element drift. The cure is loading the matching valve body data, not a new solenoid.
Possible causes
- Replacement TCM fitted without solenoid C data high
- Valve body or solenoid assembly swapped without updating the TCM high
- Stored data corrupted, checksum no longer matches low
Symptoms
- MIL on in the first drive after the fault
- Slipping or harsh application of the clutch fed by valve C
- On the CVT, unstable line pressure and belt slip risk
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P27A9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.