OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27A7

Pressure Control Solenoid A Data Incompatible

P27A7 means the transmission controller holds no usable calibration curve for pressure control solenoid A. Each valve body is measured at the factory, and GM writes its current-to-pressure data into TCM memory; at every start-up the module checks that record. GM's 2020 table 20OBDG04 flags it when the data are missing after a replacement or brand-new TCM is fitted, belong to another solenoid class, fail the checksum, or contain axis points that fall instead of rise, rated Type A after one trip. On the nine-speed valve A is line pressure, on the ten-speed clutch C1, on the CVT the secondary pulley; the 2019 hybrid table 19OBDG01 lists it in the HPC1 too. The MIL comes on, and shifting is usually rough until the data are reprogrammed.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / A7

Possible causes

  • New or service TCM installed without loading the solenoid characterization data high
  • Valve body replaced but the data for its part number not written to the TCM high
  • Data set for a different solenoid class or valve body entered medium
  • Programming aborted, leaving a corrupted block (checksum error) low

Symptoms

  • MIL on right after start-up
  • Harsh engagements or firm shifts from imprecise line pressure
  • Transmission may run a substitute program

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P27A7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication