OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27A4

Electric/Auxiliary Transmission Fluid Pump B Control Circuit Low

P27A4 indicates that the control line of auxiliary pump B is pulled toward ground. The module checks the line while its driver is switched on; if the measured level stays close to zero, the circuit counts as shorted low. No manufacturer documents P27A4 publicly. GM's 2025 TCM tables give the mirror test for pump A as P2798: under 0.5 Ω between signal and controller ground in more than 20 of 25 samples at 100 ms spacing, evaluated only with battery voltage between 9 and 15 V and the feeding high-side driver on; it is Type B, so the MIL follows after two trips. A short of this kind can also blow a fuse or trip the driver's overcurrent protection. Check for insulation worn through against the housing or subframe and for water in connectors. P27A5 covers the high side.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / A4

Possible causes

  • Control wire insulation chafed through to ground high
  • Water or corrosion bridging pins to ground in the pump connector medium
  • Internal short to ground inside pump B low

Symptoms

  • Stop-start unavailable
  • MIL or transmission warning after repeated trips
  • Blown fuse in the pump supply possible

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P27A4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication