OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P27A2

Electric/Auxiliary Transmission Fluid Pump B Control Circuit/Open

P27A2 flags a broken control circuit between the module and auxiliary pump B, the second electric fluid pump on gearboxes that carry two. While its output is energised, the controller compares the voltage on the line with the level an intact load would pull it to; a floating line reveals the interruption. No manufacturer documents P27A2 publicly. GM's 2025 TCM tables describe the identical test for pump A as P2796: more than 200 kΩ to ground in at least 20 of 25 samples taken every 100 ms, with 9 to 15 V supply, Type B. Audi ties its pump B codes to the gear oil pump V553 of the 0CJ, 0CK and 0CL twin-clutch units. P27A4 and P27A5 are the shorted variants. Typical faults are a cracked wire, a pushed-back pin or an open motor winding; stop-start is normally withdrawn.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / A2

Possible causes

  • Control wire broken in the harness to pump B high
  • Pump connector unplugged, pin pushed back or corroded medium
  • Open motor winding or internal connection in pump B medium

Symptoms

  • Stop-start no longer active
  • Transmission warning or MIL
  • Harsh engagement when driving off after a restart

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P27A2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication