P27A0
Four Wheel Drive (4WD) Range Signal Circuit High
P27A0 is logged when the line reporting which transfer case range is engaged (4WD high, 4WD low, neutral) reads above its highest valid level. Range encoders usually present a defined voltage or resistance band for each position; a value above all bands typically means the wire is open and pulled up inside the module, the encoder lost its ground, or the line touches a battery feed. No manufacturer documents P27A0 publicly. GM's 2008 Two-Mode Hybrid tables carry the same range information under P279D, and CARB 13 CCR 1968.2 asks for out-of-range checks on such inputs. P279F is the low-side partner, P279E the plausibility fault. With the range unknown, the module may refuse range changes or fall back to a default torque strategy.
Possible causes
- Range signal wire or encoder ground interrupted (corroded or loose connector near the transfer case) high
- Signal wire chafed against a powered conductor medium
- Transfer case range encoder or switch defective medium
Symptoms
- 4WD indicator flashing or showing no range
- Shift between 4WD high and low refused
- Warning lamp or driveline message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P27A0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.