OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P279C

Transfer Case Gear Neutral Incorrect Ratio

P279C applies when neutral is commanded on the transfer case, as is done for flat towing, but the shafts still turn with a fixed ratio that matches high or low range. The transfer case therefore still transmits drive. GM's 2019 ECM tables (LCV section) use the same output-speed ratio as for the other two range tests, but allow more time before deciding: the failure must last 10.5 seconds within a 15-second window. Enable conditions again require output shaft speed above 500 rpm, engine torque and pedal input and no PTO use; the fault is Type A. For towing this matters: a vehicle believed to be in neutral can drive the transmission and damage it. Range motor problems, a sticking shift sleeve and incorrect position feedback are the main suspects; P279A and P279B are the high and low counterparts.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 9C

Possible causes

  • Range shift motor not reaching neutral high
  • Sticking shift sleeve keeping a range engaged medium
  • Wrong position feedback from the range sensor medium

Symptoms

  • Vehicle still drives or creeps with neutral selected
  • Neutral request rejected, 4WD warning on
  • MIL on

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P279C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication