P279B
Transfer Case Gear Low Incorrect Ratio
P279B is the reverse case of P279A: 4WD low has been commanded, yet the transfer case behaves like high range or neutral. For a vehicle crawling off-road this is a real safety concern, because the expected reduction and engine braking are missing. In GM's 2019 ECM tables (LCV section) the module divides transmission output speed by transfer case output speed and flags the fault if the result lands in the high or neutral window. Timing and conditions match the high-range test: 7 s of failure within 10 s, output shaft above 500 rpm, engine torque and pedal applied, no PTO and no active speed sensor faults; Type A, so one failing trip turns on the MIL. A shift motor that stalls before the low position, worn planetary teeth or a broken fork are the likely culprits. P279C covers neutral.
Possible causes
- Shift motor stopping short of the low position high
- Worn or damaged reduction planetary set medium
- Broken or bent range shift fork medium
- Faulty speed signal distorting the ratio low
Symptoms
- No reduction in 4WD low, weak crawling and engine braking
- 4WD warning lamp and MIL
- Clunking or grinding when selecting low range
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P279B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.