OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2799

Electric/Auxiliary Transmission Fluid Pump A Control Circuit High

P2799 is set when the control line of auxiliary pump A sits at too high a level, normally because it touches a powered wire. GM's 2025 TCM tables are the only public manufacturer description: the module measures under 0.5 Ω from the signal line to a voltage source in 20 of 25 samples spaced 100 ms apart, provided supply voltage is between 9 and 15 V, and treats the result as Type B with the MIL after two trips. The tables also show that the pump may be fed by one of several high-side drivers, and the check only runs while the relevant driver is on. CARB requires such actuator circuits to be monitored for shorts. Look for chafed harness sections near hot or moving parts and pins bridged by moisture. With the pump unusable, stop-start and pressure support at restart are lost.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 99

Possible causes

  • Control wire shorted to a powered circuit high
  • Moisture bridging pins in the pump connector medium
  • Internal short in the pump electronics medium
  • Faulty high-side driver in the module low

Symptoms

  • MIL after two drive cycles
  • Stop-start inoperative
  • Rough engagement after an auto-start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2799

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication