P2796
Electric/Auxiliary Transmission Fluid Pump A Control Circuit/Open
P2796 points to an interrupted control line between the module and the motor of auxiliary pump A. GM's 2025 TCM tables define the test: provided the battery supplies 9 to 15 V, the controller sees more than 200 kΩ from signal to ground in at least 20 of 25 samples taken every 100 ms; the code is Type B, so the MIL comes on after two trips. On Ford's 10R60/10R80 and 8F57 automatics the pump itself reports that the PWM command signal is missing, filed as P2796_31. Ford TSB 26-2010 covers the 2022–2025 F-150 Lightning, where P2796 or P2797 in the secondary OBD modules B and C may stem from software, often first logged at 0 °C or below; reprogramming is the fix. P2798 and P2799 are the short-circuit siblings, P27A2 the same fault on pump B.
Possible causes
- Broken control wire or unplugged pump connector high
- Poor terminal contact at the pump or module medium
- Module software (Ford F-150 Lightning, TSB 26-2010) medium
- Open circuit inside the pump electronics low
Symptoms
- MIL or wrench indicator on
- Stop-start inoperative
- Reduced performance message on electrified models
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2796
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.