OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2794

Gear Shift Direction Circuit Low

P2794 means the shift direction signal, which tells the controller whether a gear is being pushed in or pulled out along its lane, reads lower than the permitted minimum. The usual suspects are a signal line rubbed through to ground, a collapsed sensor supply shared with other sensors, or water in a connector creating a leakage path to ground. Because the same supply often feeds several gearbox sensors, other low-voltage codes stored at the same time point to the supply rather than this sensor. No manufacturer documents P2794 publicly with thresholds; the test is one of the range checks CARB 13 CCR 1968.2 sets for transmission inputs. P2793 covers a missing or invalid signal and P2795 the opposite limit. With this fault the gearbox normally freezes the gear in use.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 94

Possible causes

  • Signal line chafed through to ground high
  • Shared sensor supply pulled down by another sensor or wiring medium
  • Moisture or corrosion in the connector medium
  • Shift direction sensor failed low low

Symptoms

  • Gearbox stays in the current gear
  • Manual shift requests ignored
  • Transmission warning lamp

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2794

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication