OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2793

Gear Shift Direction Circuit

P2793 covers the circuit that reports the shift direction, the fore-and-aft movement along a lane that actually engages or releases a gear, as opposed to the sideways lane choice monitored by P2790. Depending on the design, an automated manual reads it from a sensor on the shift actuator, while shift-by-wire systems may take it from the lever or a separate selector module. The controller stores the circuit fault when the signal is absent or not valid at all; signals that are present but too low or too high set P2794 or P2795. No manufacturer documents P2793 publicly with set conditions; CARB 13 CCR 1968.2 requires such inputs to be checked for circuit integrity. If the controller cannot tell which way the shift is going, it usually stops shifting, keeps the engaged gear and turns on the warning lamp.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 93

Possible causes

  • Open circuit or poor contact at the shift direction sensor connector high
  • Failed shift direction sensor on the actuator medium
  • Faulty shift lever or selector module where it sends the signal medium
  • Transmission controller input fault low

Symptoms

  • No up- or downshifts, gearbox keeps the current gear
  • Selector input ignored
  • Warning lamp and transmission message

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2793

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication