OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2792

Gate Select Direction Circuit High

P2792 reports a gate select direction signal stuck above its valid band. Common reasons are a short between the signal line and a supply voltage, a broken sensor ground that lets the input float up, or an open signal wire on inputs with an internal pull-up resistor; a sensor with a failed output stage can also hold the line high. Which hardware provides the signal, actuator sensor or lever module, depends on the maker, and none of them documents P2792 publicly with limits. The test belongs to the out-of-range checks of CARB 13 CCR 1968.2 for transmission inputs. P2791 is the low-side counterpart and P2790 the general circuit fault. Typical effects are blocked sideways selection, shifts limited to one lane and a transmission warning.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 92

Possible causes

  • Signal wire shorted to a supply voltage high
  • Broken sensor ground or open signal line pulled up internally medium
  • Select direction sensor failed with high output medium

Symptoms

  • Sideways selection blocked, shifts possible only in one lane
  • Gearbox may stay in gear or neutral
  • Transmission warning lamp

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2792

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication