OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2790

Gate Select Direction Circuit

P2790 is the basic circuit fault for the signal that tells the controller in which direction the selector mechanism is moving across the gate, that is sideways between the shift lanes of the H pattern. In automated manual gearboxes the select actuator or its sensor provides this information; on some shift-by-wire levers it comes from the lever itself, so the exact part depends on the manufacturer. A circuit code means the signal is missing or of the wrong type, for example an open wire or a dead sensor, rather than a value that is merely too low or too high (those are P2791 and P2792). No manufacturer documents P2790 publicly; CARB 13 CCR 1968.2 requires circuit checks for such gearbox inputs. Results range from refused gear changes to a vehicle that stays in one gear or will not pull away.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 90

Possible causes

  • Open wire or loose, corroded connector at the select sensor high
  • Failed select direction sensor or select actuator electronics medium
  • Fault in the shift lever module where it supplies the signal low
  • Defective input stage in the transmission controller low

Symptoms

  • Gear changes refused or gearbox stuck in one gear
  • Vehicle may not move off from standstill
  • Warning lamp with transmission message

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2790

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication