OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P277E

Clutch A Unexpected Mechanical Gear Disengagement

P277E reports that a gear on the shaft served by clutch A dropped out of engagement by itself while that clutch was carrying the drive, without any shift being commanded. GM's 2023 TCM tables for its dual-clutch gearbox run this check continuously: if the synchronizer of the driving gear shows a speed difference although the odd-gear clutch slips by less than 50 rpm, and this lasts 1000 ms, the code is stored as Type A with immediate MIL. Ford's 2024 OBD summary lists it for the TR9070 dual-clutch unit as an unintended disengagement on the shaft carrying the odd gears. P277F covers the even shaft, P2711 is the generic version without a clutch letter. Drivers notice a sudden loss of drive or a jump to neutral, usually followed by limp mode with some gears blocked.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 7E

Possible causes

  • Worn shift-fork detent or rounded engagement teeth on an odd gear high
  • Shift rod drifting due to internal hydraulic leakage or a weak actuator medium
  • Fork end positions not relearned after repair or module replacement medium
  • Faulty shaft speed signal making a slip appear at the synchronizer low

Symptoms

  • Sudden loss of drive as if the gearbox had shifted into neutral
  • Odd gears locked out, limp mode with reduced gear choice
  • Warning lamp and transmission message in the cluster

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P277E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication