OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P277B

Electric/Auxiliary Transmission Fluid Pump B Driver Circuit Performance

P277B concerns the power stage that energises the motor of auxiliary pump B, wherever it sits: inside a separate pump controller or in the transmission module. The stage is switched on, but what comes back – current, speed or a status signal – does not fit the command, so the module rates the driver as implausible rather than reporting a plain open or short. No manufacturer documents P277B publicly. For pump A, Ford's 2024 OBD summary (10R60/10R80, 8F57) lists a related case: the pump flags implausible current together with implausible speed, stored as P0C29 (UDS P0C29_92). Overheated or failing driver electronics, a poor ground, low system voltage and a pump that loads the stage abnormally are the usual triggers. The gearbox then runs without the pump's support, which mainly affects stop-start.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 7B

Possible causes

  • Failing output stage in the pump controller or TCM high
  • Poor ground or low system voltage at the driver medium
  • Pump motor loading the driver abnormally medium
  • Loose or corroded pins between driver and pump low

Symptoms

  • Transmission warning or service message
  • Stop-start unavailable
  • Jerky drive-off after engine restarts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P277B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication