P2778
Upshift Switch Circuit Intermittent/Erratic
P2778 is meant for an upshift switch signal that jumps around or drops out briefly instead of staying in one state. No manufacturer documents P2778 publicly. GM's 2023/2024 twin-clutch TCM and Ford's TR9070 split the same paddle input into low, high, implausible and stuck faults (P2775–P2777, P0815) but list no intermittent check, so on those cars a flickering contact will rather end up as one of these. CARB expects inputs to be watched for circuit and rationality faults, which is the frame this code fits. Practical causes are a clock spring with a cracked track that opens at certain wheel angles, a loose crimp in the column connector, or a worn paddle contact. Symptoms come and go: occasional ignored upshifts or unwanted gear requests.
Possible causes
- Clock spring track cracked, opening at certain steering angles high
- Loose terminal or poor crimp in the column or wheel connector medium
- Worn or bouncing contact in the paddle medium
Symptoms
- Upshift requests occasionally ignored
- Occasional unwanted upshift requests
- Fault comes and goes, often depending on steering angle
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2778
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.