P2774
Four Wheel Drive (4WD) Low Switch Circuit High
P2774 reports that the low-range switch input sits above its valid voltage range. With a pulled-up signal line this usually points to an open circuit, a broken ground at the switch or a short to battery voltage. No manufacturer documents P2774 publicly; the monitoring logic follows the CARB demand for out-of-range checks on inputs, and the switch itself is the one GM and Toyota describe under P2771. A connector pushed off at the transfer case after service work or a wire torn by the propeller shaft are frequent physical reasons. In contrast to P2773 the module sees too much voltage, and in contrast to P2772 the reading is not merely implausible but outside the electrical window. Low range may be unavailable or the 4WD lamp may flash.
Possible causes
- Open signal or ground wire, connector unplugged at the transfer case high
- Signal wire shorted to battery voltage low
- Switch contacts open internally medium
Symptoms
- Warning light and flashing 4WD indicator
- Low range not recognised after selection
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2774
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.