P2773
Four Wheel Drive (4WD) Low Switch Circuit Low
P2773 is stored when the signal line of the low-range switch stays below its permitted voltage band, typically because it is pulled to ground. No manufacturer documents P2773 publicly. Toyota shows that the fault type exists in practice but files it differently: on 2024–2025 Tacoma the short to ground appears as P2771 with failure byte 11, and bulletin T-SB-0093-25 traces it to a shift actuator damaged through the transfer case breather. Typical triggers for a low signal are chafed insulation touching the body, water in the actuator or connector, or a switch shorted internally. Unlike P2772 this is a purely electrical finding, and unlike P2774 the reading is too low rather than too high. The vehicle may ignore low range or default the 4WD system.
Possible causes
- Signal wire chafed through and shorted to ground high
- Moisture in shift actuator or connector (Toyota Tacoma breather issue) medium
- Low-range switch shorted internally medium
Symptoms
- 4WD indicator flashing and warning light on
- Low range cannot be selected or is reported permanently
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2773
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.