OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2771

Four Wheel Drive (4WD) Low Switch Circuit

P2771 concerns the input that reports whether the transfer case sits in its low range. GM uses it on 2016 Silverado/Sierra with the MW7 gearbox as a plausibility test in the TCM: if the switch says high range while gear ratio math says low, or the reverse, for at least 0.5 s with fluid between 20 and 130 °C, the Type B code sets. The 2014 LML diesel ECM runs a similar comparison from turbine speed, output speed and ratio. GM's PIP4966B links P2771 on 2007–2011 trucks with Magna transfer cases to a speed-sensor tone wheel shifting on its shaft, or output shaft play, that corrupts the speed signal. Toyota's T-SB-0093-25 shows P2771 with subtype 11 (short to ground) on 2024–2025 Tacoma, fixed with a new shift actuator and breather hose. P2772–P2774 split the fault types.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 71

Possible causes

  • Loose tone wheel or moving output shaft in the transfer case (GM PIP4966B) medium
  • Transfer case shift actuator damaged, e.g. by water through the breather (Toyota Tacoma) medium
  • Low-range switch or position encoder defective medium
  • Damaged wiring or corroded connector between switch and control module low

Symptoms

  • Check engine light, often together with a flashing 4WD indicator
  • Erratic speedometer or ABS warning when a speed signal is affected
  • Low range not engaging, or transfer case disengaging under load

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2771

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication