OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2770

Torque Converter Clutch Circuit High

P2770 flags a high level on the torque converter clutch circuit, meaning a short to the battery supply on the TCC solenoid or its wiring. Ford documents it in the 2024 OBD summary for the 6R80, 6R140, 10R60/10R80 and the 8F front-drive families: P2770 corresponds to UDS P0740_12, while P0740_13 covers an open line and P2769 (P0740_11) a short to ground. One table even shows P0744, the older code for the same short to power, beside P2770 under the same failure byte. The electrical check runs at all times; the stated monitoring duration for an electrical fault is 5 seconds. The TCM then keeps the converter unlocked, so cruising rpm and fluid temperature rise and fuel use worsens. A harness rubbing against a powered wire or a damaged case connector are the usual finds.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 70

Possible causes

  • TCC circuit chafed against a powered wire high
  • Damaged or contaminated transmission case connector medium
  • Internal short in the TCC solenoid medium
  • Faulty TCC output driver in the TCM/PCM low

Symptoms

  • MIL on
  • No converter lockup, higher rpm at highway speed
  • Higher fuel consumption and fluid temperature

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2770

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication