P276F
Electric/Auxiliary Transmission Fluid Pump B Motor Current High
P276F is stored when the motor of auxiliary pump B pulls more current than the module allows. Excess draw points to a motor that is working too hard or is electrically damaged: a dragging bearing, debris or varnish in the pump, very cold thick fluid, a partially shorted winding or a chafed lead touching ground. No manufacturer documents P276F publicly. Ford's 2024 OBD summary shows the matching pump A logic for the 10R60/10R80 and 8F57 transmissions, where the pump itself reports an over-current that the TCM files as P0C28 (UDS P0C26_19). To protect wiring and electronics, most controllers then switch the pump off, so the vehicle loses the functions that depend on it. If the motor stops completely, P277C is the more specific code; P276E is the low-current sibling.
Possible causes
- Dragging bearing or debris inside pump B high
- Partially shorted motor winding medium
- Chafed pump lead shorting to ground medium
- Contaminated or wrong-viscosity transmission fluid low
Symptoms
- Warning lamp with transmission fault message
- Stop-start function disabled
- Possible whine or rattle from the pump area
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P276F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.