OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P276D

Electric/Auxiliary Transmission Fluid Pump B Motor Current

P276D is the general current code for the motor of auxiliary transmission pump B: the measured current does not fit the commanded speed or load, without the module saying whether it is too low or too high. The narrower siblings P276E and P276F carry that distinction, and P0C26 is the same check for pump A. No manufacturer documents P276D publicly. For the component, Audi's bulletin 34-17-25 names the gear oil pump V553 as pump B in its 0CJ, 0CK and 0CL dual-clutch gearboxes and describes an assembly defect that made the pump rattle. CARB requires that electric actuators are checked for proper function. Worn brushes or bearings, a jammed impeller, contaminated fluid or a bad ground typically change the current draw before the pump fails.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 6D

Possible causes

  • Worn bearings or binding impeller in pump B high
  • Contaminated or wrong transmission fluid medium
  • Poor ground or connector resistance at the pump medium

Symptoms

  • Noise from the pump area
  • Transmission warning lamp
  • Stop-start or shift quality restricted

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P276D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication