P276C
Electric/Auxiliary Transmission Fluid Pump B Motor Supply Voltage Circuit High
P276C flags an excessive voltage on the motor supply of auxiliary pump B. Either the circuit is shorted to another powered line, the pump module measures wrongly, or the vehicle charging system itself overshoots. No manufacturer documents P276C publicly. Audi's bulletin 34-17-25 identifies pump B on its 0CJ, 0CK and 0CL dual-clutch units as the gear oil pump V553 and lists the low-voltage sibling P276B for it; P0B0B is the matching high code for pump A. CARB requires actuators to be watched for out-of-range electrical values. An overvoltage can overheat the pump electronics, so many modules switch the pump off. Before replacing parts, measure the charging voltage at running engine and inspect the supply wiring for chafing.
Possible causes
- Charging system voltage too high medium
- Supply wire shorted to another powered circuit medium
- Faulty measurement in the pump control electronics medium
Symptoms
- Transmission warning lamp
- Pump switched off, stop-start unavailable
- Other overvoltage codes if charging is at fault
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P276C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.