P276B
Electric/Auxiliary Transmission Fluid Pump B Motor Supply Voltage Circuit Low
P276B is set when the supply voltage reaching the motor of auxiliary transmission pump B sags below its lower limit. Audi names this code in bulletin 34-17-25 (revision of September 2017) covering 2017 A4/A5/A6 models and the 2018 Q5 fitted with the 0CJ, 0CK or 0CL twin-clutch gearbox. Pump B there is the gear oil pump V553, and P276B00 may appear together with lost communication U28A00, stuck-on P27A600 and performance P27A300. The bulletin attributes a rattle from under the car to a supplier assembly issue and calls for a new pump with new bolts; transmission fluid must not reach the electrical connector during removal. Apart from that case, weak batteries, high-resistance grounds and partial shorts can pull the voltage down.
Possible causes
- Defective gear oil pump V553 (Audi 0CJ/0CK/0CL) high
- High resistance in supply or ground of the pump medium
- Low system voltage from a weak battery low
Symptoms
- Rattle noise from under the vehicle (Audi)
- Transmission warning lamp
- Further pump B codes stored
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P276B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.