OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2769

Torque Converter Clutch Circuit Low

P2769 reports a low level on the converter clutch circuit, in practice a short to ground. It belongs to the P0740 family for converters with a single TCC solenoid, unlike P2764, which refers to a dedicated pressure control solenoid. Ford uses it in its 2024 OBD summary for the 6R80, 6R140, 10R60, 10R80 and the 8F front-drive units: P2769 carries failure byte 11 (short to ground), P2770 byte 12 (short to power) and P0740 byte 13 (open). The electrical test runs continuously and flags a mismatch between driver feedback and commanded state lasting 1.5 seconds. The TCM then disables lockup, so engine speed stays higher at cruise and fluid temperature climbs. A pinched harness at the case connector or a shorted coil are typical.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 69

Possible causes

  • TCC control wire pinched or chafed to ground high
  • TCC solenoid coil shorted medium
  • Damaged internal transmission harness or lead frame low

Symptoms

  • No converter lockup
  • Higher rpm and fuel use at highway speed
  • Check engine lamp on

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2769

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication