OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2767

Input/Turbine Shaft Speed Sensor B Circuit No Signal

P2767 reports that pulses from sensor B are missing. Ford's DPS6 dual-clutch box of 2012 checks input shaft 2 for lack of signal under this code, alongside P2765 for circuit faults and P2766 for erratic readings. Mitsubishi's 2022 CVT, whose sensor B watches the secondary pulley, looks for a sudden collapse: a speed of at least 1,000 rpm that reads zero only 10 ms later, held for 0.5 s – a pattern typical of a wire or plug letting go, rather than a slow sensor death. It is a two-trip code with MIL there; the fail-safe gives slow starts and acceleration, no lock-up and no manual mode. Check connector and harness first, then the sensor; where B sits inside a sealed unit, the repair may involve the whole assembly.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 67

Possible causes

  • Connector or terminal letting go, open signal wire high
  • Sensor B failed with no output medium
  • TCM sensor input defective low

Symptoms

  • Warning lamp and transmission fail-safe
  • Slow start-off and weak acceleration
  • Manual shift mode not available

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2767

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication