OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2765

Input/Turbine Shaft Speed Sensor B Circuit

P2765 is the circuit code of a second input speed sensor, B, and what B measures varies. On Ford's DPS6 dual-clutch box (2012) it is the input shaft 2 sensor for reverse and the even gears, faulted when the TCM hardware detects a circuit failure. Audi bulletin 2032211/3 for the 0B5 S tronic (S4/S5 2010–14, RS5/S6/S7 2013–14) lists P2765 among codes caused by a faulty sensor module G676 carrying the input speed sensors; it is replaced with its harness, which means removing the gearbox. Nissan's NTB14-019 (2014 Rogue, CVT8) ties P2765 to moisture on the pins of the secondary speed sensor. Mitsubishi's 2019 CVT uses it for the turbine sensor: under 150 rpm for 5 s with the primary pulley above 500 rpm.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 65

Possible causes

  • Moisture or corrosion at the sensor B connector pins high
  • Defective sensor B or integrated sensor module inside the gearbox medium
  • Open or shorted wiring between sensor and TCM medium
  • TCM input stage faulty low

Symptoms

  • Check engine light and gearbox malfunction message
  • Limp-home mode, sometimes without reverse or even gears
  • Slow take-off and no torque converter lock-up

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2765

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication