OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2764

Torque Converter Clutch Pressure Control Solenoid Control Circuit Low

P2764 is the low counterpart of P2763: the lockup solenoid circuit is pulled toward ground. GM's 2018 T87A table defines it as 0.01 Ω or less to vehicle ground, checked while the driver is off every 6.25 ms. In 2016, the T76 six-speed sets it on a ground-short flag in 4.4 of 5 seconds after a single trip, and the T54 CVT when the hardware sees a ground short for 480 ms or longer while lockup is on. FCA's remanufactured-transmission note for the 62TE adds a twist: if P0740 or P2764 come with jerking or slipping and the solenoid tests good, the torque converter itself has failed and must be replaced. Ford's 2012 6R80 also monitors its TCC driver under this code. Lockup is usually disabled until repair.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 64

Possible causes

  • Control wire shorted to ground high
  • Solenoid winding shorted to its housing medium
  • Failed torque converter when the solenoid tests good (FCA 62TE) medium

Symptoms

  • No lockup and higher fuel consumption
  • Jerking or slipping (62TE)
  • MIL after one trip on some GM units

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2764

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication