OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2763

Torque Converter Clutch Pressure Control Solenoid Control Circuit High

P2763 means the control circuit of the lockup pressure solenoid reads high. GM's 2018 T87A table treats it as a short to power, at 1.16 Ω or less to a voltage source while the driver is on, Type B. Its 2016 tables add variants: on the T76 six-speed the high-voltage flag also covers an open circuit and must persist 4.4 of 5 seconds over two trips; on the T54 CVT the module sets it when at least 750 mA is commanded but 200 mA or less flows for over 5 seconds. Subaru cites P2763 in bulletin 16-149-25 for the TR580 CVT in 2020–2023 Legacy, Outback, Crosstrek and Forester Wilderness: condensation can wet the valve-body connector, cured with a redesigned control valve plus connector cover. Ford's 2012 6R80 also files TCC driver faults here.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 63

Possible causes

  • Moisture in the valve-body connector (Subaru TR580) high
  • Control wire shorted to battery voltage medium
  • Open circuit where the maker includes it in this code (GM T76/T54) medium
  • Faulty TCM output stage low

Symptoms

  • No converter lockup, higher cruise rpm
  • Transmission warning and MIL
  • Other solenoid high codes at the same time (Subaru)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2763

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication