OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2762

Torque Converter Clutch Pressure Control Solenoid Control Circuit Range/Performance

P2762 covers a solenoid circuit that is neither open nor shorted but does not behave as commanded. In GM's six-speed TCM tables for the MW7 (2016) and T87A (2018) the module compares desired with measured solenoid current; a gap of 0.5 A or more in at least 40 of fewer than 80 samples sets the code as Type B, with battery voltage above 10 V. For the T76 six-speed of 2016, GM instead calls it a rationality test that fails when the hardware layer reports an out-of-range voltage in 4.4 of 5 seconds, and lists it without MIL. Rising coil resistance, a weak supply or ground, or a current-sensing fault in the TCM are typical. Lockup may feel harsh or soft, since the pressure no longer follows the target.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number7 / 62

Possible causes

  • Solenoid coil resistance out of specification high
  • Weak supply voltage or poor ground at the TCM medium
  • High-resistance terminal in the circuit medium
  • Current sensing fault inside the TCM low

Symptoms

  • Harsh or slipping converter lockup
  • Shudder at light throttle in higher gears
  • Warning lamp depending on application (GM T76 none)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2762

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication